How the DogWatch Hidden Fence System Works
The boundary wire creates the perimeter for the DogWatch Hidden Fence System, and can enclose any area up to 200 acres. It is buried at least 3 - 4” beneath the surface of the yard or can lie on top of the ground (e.g.: in wooded or rocky areas). It can also be installed around gardens or swimming pools, or attached to an existing fence to prevent your dog from digging under or jumping over it.
Boundary Wire: The boundary wire carries the coded radio signal around the perimeter of your property. It is rated for underground burial.
Signal Field: The radio signal is transmitted from the boundary wire in all directions. It can be used to keep dogs in or out of an area. The signal is adjusted by the Range control on the Transmitter to create a signal field on each side of the wire. Your Dealer has installed the wire to the recommended width of 8-10 feet and has carefully configured the corners to avoid sharp angles.
Continuous Loop: In order for the system to work properly, the boundary wire must form a continuous loop. Any break in the wire will cancel the signal field. If the boundary wire is broken or unplugged, the green Loop Monitor Display (LMD) light will go out and an audible warning will sound. Most breaks are caused by lawn/garden equipment. If you cannot visibly locate the break, contact your Authorized Dealer for service.
Surge Protector: For maximum protection against power surges, DogWatch offers both internal an external surge protection. It is important that the surge protector be properly grounded. This part of the system protects the transmitter from damage due to lightning power surges. Your Dealer has attached it to the existing electrical source house ground or a grounding rod and then connected it to the twisted wire between the transmitter and the boundary wire. After a lightning storm, check to be sure your transmitter is working properly. Do not let your dog outside until you know the system is operating.
<< Back to Resources
Brought to you by Barrett Communications
Boundary Wire: The boundary wire carries the coded radio signal around the perimeter of your property. It is rated for underground burial.
Signal Field: The radio signal is transmitted from the boundary wire in all directions. It can be used to keep dogs in or out of an area. The signal is adjusted by the Range control on the Transmitter to create a signal field on each side of the wire. Your Dealer has installed the wire to the recommended width of 8-10 feet and has carefully configured the corners to avoid sharp angles.
Continuous Loop: In order for the system to work properly, the boundary wire must form a continuous loop. Any break in the wire will cancel the signal field. If the boundary wire is broken or unplugged, the green Loop Monitor Display (LMD) light will go out and an audible warning will sound. Most breaks are caused by lawn/garden equipment. If you cannot visibly locate the break, contact your Authorized Dealer for service.
Surge Protector: For maximum protection against power surges, DogWatch offers both internal an external surge protection. It is important that the surge protector be properly grounded. This part of the system protects the transmitter from damage due to lightning power surges. Your Dealer has attached it to the existing electrical source house ground or a grounding rod and then connected it to the twisted wire between the transmitter and the boundary wire. After a lightning storm, check to be sure your transmitter is working properly. Do not let your dog outside until you know the system is operating.
<< Back to Resources
Brought to you by Barrett Communications
